Pit Survey Form

The information requested on this form is required to enable Majorlift to supply a pit jack to you.

Equipment built to Last

Your pit jack will fit into your pit and be operational within minutes of being delivered. It will not foul on lights, air pipes or electricity supply. With your help we will get it right first time.

Either complete the online form below or if you prefer DOWNLOAD an Adobe PDF version which may be filled in and faxed back to us on 01454 294003.

Pit Jacks Rated Up To 40 Tonnes

Minimum distance between ram centres: 180mm

Height from rams to rails: 426mm

Height from rails to top of locking collar: 70mm

Pit edge profiles

Pit Transmission Jack PTJ1000

Diagram Reference 1 - Minimum axle to ground clearance. Lowest vehicle in your fleet

Diagram Reference 2 - Have you angle or channel sections ?

Angle
Channel

Diagram Reference 2 - Is the surface where the wheels will run flat or tapered ?

Flat
Tapered

Diagram Reference 3 - Measurement of the depth of angle or channel section from the workshop floor.

Diagram Reference 4 - Width of pit, check this along the length of your pit at this point between pit rails, at 1 metre intervals as indicated on diagram.

Width of pit (Minimum)

Diagram Reference 5 - Width inside vertical flanges of the pit rails, at 1 metre intervals as indicated on diagram.

Width inside vertical flanges of rail (Minimum)

Diagram Reference 6 - Distance to the top of any Lights, Air or Electricity Supply that intrude into the pit. (Left is facing the operating controls of a Pit Jack)

Distance to the top of any Lights (Right side)

Diagram Reference 7 - Distance from pit wall that any Lights, Air or Electricity Supply that intrude into the pit. (Left is facing the operating controls of a Pit Jack)

Distance to the top of any Lights (Right side)

Diagram Reference 8 - Depth of pit

Please advise any other information on the pit construction not mentioned above which you think is relevant.

Form completed by *

Email *

Comment